Product DescriptionInstructions:1,There is a layer of anti-rust protective film on the cast iron plate, and the protective film will evaporate due to heating when it is used for the first time. Therefore, it is normal to produce smoke and odor when you use it for the first time, and there will be no smoke and odor after evaporation. It is recommended that you put it in a ventilated position for 10-20 minutes to evaporate the protective film when using it for the first time.2,The electric heating furnace has a temperature control switch. According to the working principle of the constant temperature furnace,The red light below the outer casing will go out when the electric furnace reaches the temperature you adjust. When it is lower than the temperature you adjust, the red light will be on, cycle work, and automatically keep warm. This is a normal phenomenon, don't worry.3,In the process of using the furnace, please do not touch the furnace body with your hands.It is recommended that you use the third to avoid overheating.Operational Rules:Rotate the electric stove switch to operate and there are 5 ranges to adjust the temperature of the electric stove. Adjust the switch to the appropriate range to make the electric stove reach the required temperature. Please note that turn the switch to the "0"/"off" position and unplug the plug when not in use.Colour: Blackmaterial: metalSafety Precautions:1. Cannot leave when using.2. Do not touch the stove while heating.3. Do not immerse the electric stove in water or other liquids.4. The electric stove is for cooking food, the utensils should be put on the heating plate when you cooking.5. When the electric stove is not in use, be to turn the switch to the "0"/"off" position and unplug the plug.Package Contents:1x Electronic hot plate1 x candle making pot1 x Mixing spoonOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.