Shop name:Chong Qing Shuo Yue Ke Ji You Xian Gong Si How to bind the transmitter to the receiver? 1).Check and make all the wires are mounted,and the remote is CLOSED,insert the bind plug into CH3(Bind) on the receiver;2).Switch on the ESC,you can see the receiver red light flash; 3).Press and hold on the bind button on the remote and then turn the remote on; 4).You should notice the transimitter go from flashing red to solid red,and also the solid red of the receiver; 5).Once you see a solid red light, you now know the two are binded together,and please pull the bind plug out (this is important,so the remote can record the throttle mid to realize the fail safe) 6).Then you can test it again by turning off the controller and it should if you turn the power on Transmitter back on it should go back to solid red.Before running,it's better to test the fail safe fuction by closing the remote,if the motor didn' move,so the fail safe fuction is in good condition,when you find the motor is moving,you have to repeat No.1- No.6 above Board Category: Flat-Plate Applicable People: Men Type: Electric Skateboard Frequency: 2.4Ghz Battery: 3.7v 500mAh Li-po Battery Channel: 2 channel increase the throttle range about 15%; add an extra antenna inside to strengthen the signal. Better quality lithium battery. Mini Remote Controller 2.4Ghz Weight: 48g Frequency: 2.4G Channel: 2 channels (throttle and LED light) Application of ESC: All ESC Power:Li-po 3.7v 500mAh(included) Suitable for : Electric skateboard longbaord USB Charge spot (USB line do not inclueded,as it is suitable for normal USB line) colour:black Material:plastic size:100x52x20mm Package Contents: 1 * remote control 1 * receiver 1 * USB charging cable Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.