and high qualityPICKIT3 Programmer USB (Full speed 12 Mbits/s interface to host PC) Real-time execution. MPLAB IDE compatible (free copy included)The MPLAB PICkit 3 allows debugging and programming of PIC and dsPIC Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE).The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE)Supports low voltage to 2.0 volts (2.0v to 6.0v range)Diagnostic LEDs (, busy, error)Read/write program and data memory of microcontrollerErase of program memory space with verificationFreeze-peripherals at breakpointProgram up to 512K byte flash with the Programmer-to-GoInstructions for use:Installing the microcontroller, 28-pin, 40-pin microcontroller left aligned 28/40P (A) This flag line short-circuit cap on the A positionThe 8,14,18,20-pin microcontroller aligned on the left 8P/14P/18P/20P flag line (B), shorting cap on the B positionThe ICD2, KIT2, KIT3 crystal head or 6Pin Block programming connection for programming the programming operation. (Note: a separate program of the can not be programmed the chip is programmed functions)The supports the following programming microcontroller:PIC16/18XX 40PIN Series devices (except 16F59)PIC16/18XX 28PIN Series devices (except 16F57)PIC16/18XX 18PIN Series devicesThe PIC 8PIN/14PIN/20PIN family of devices (except 10FXX)Colour:RedMaterial:plasticSize:14.5 x 7 x 4CMPackage Contents:2 * PICKIT3 Simulator2 * USB Cable2 * 6Pin cable 2 * Universal Programmer Only the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.