3d Printer Auto Leveling Sensor 3d Touch Sensor Auto Heatbed Sensor

Features simple, smart and precise. It could work with nearly any kind of bed materials, such as glasses, woods, metals and so on. The position of the point can be obtained by touching the point on the heated bed, and then compensated by adjusting the z-axis height during printing.The 3D-Touch auto leveling sensor is a device that uses the Hall defect to achieve leveling.The position of the point can be obtained by touching the point on the heated bed,and then compensated by adjusting the Z-AXIS height during printing,Printing can also be achieved even though the platcompatible withm is not flat.The main functions and controls of 3D printer touch are the same as most auto bed leveling sensors, which consists of a RC servo and a Micro-type switch,thus,3D printer touch can be used on almost every 3D printer control board.By using progressively designed solenoid and hall sensor, it can integrate high precision in such a simple structure.To make it more user-friendly and to bring you more enjoyable printing experience.NOTE: Pulling/pushing hardly on the push-pin may damage Touch sensor and make it less accurate.Specifications:Current:15mAMax current (peak): 300mAVoltage: 5VCable length:Short: 200mmLong: 1000mmWire:3pin: Green:-GND RED:+5V Orange: Signal cable2pin: Black:-GND White:Z minInstructions1.After receiving the module, do not install the module to the printer. First connect the signal wires of the module to the motherboard one by one.After power on, there will be a needle suction and push needle action, which is normal.2.When the main board and the module are powered on, do not plug and unplug the cables casually.Please be sure to connect when the power is off.3.After the firmware setting is completed, it is still uncertain whether the setting is correct. You can manually trigger the module in advanceto check whether the machine is operating normally. If it is abnormal, please stop it in time and recheck the firmware settings.Prevent the probe from hitting the platcompatible withm, causing damage to the module.size:17.70 x 12.80 x 2.90 cmMaterial:Metal + Plasticcolour:WhitePackage Contents:1 * MKS 3D Printer Touch V2.0 Auto Leveling SensorOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.