Description: 3D Printer Display Module External Display Adapter Module Spare Parts for Voron 2.4 STM32 Mini12864 3D Printer Accessories This is a dedicated board to drive Mini 12864 Display. It's intended to run for Klipper firmware. Reduce the number of wires to connect your display for VORON, no ribbon cables are required, you can plug this directly onto the back of your screen and then use a single micro USB cable for Raspberry Pi. If you receive the module, please make sure to solder the reset button and for BOOT0 jumper. You may not need the SWD interface In normal operation mode, do not skip the BOOT0 pin. It is only used when putting the board in DFU mode to flash new firmware Specification: Material: ABS plastic Size:13.5 x 42.5mm/0.5 x 1.7 inch Applicable Model: For Voron 2.4 STM32 Mini12864 Package Includes: 1 Piece Display Module Note: 1.Please allow 1~3 cm error due to manual measurement, thanks. 2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Please understand, thank you.