This non-standard passive PoE injector is a simple and convenient solution for powering PoE or non-PoE devices via an Ethernet cable. This PoE injector is compatible with IEEE802.3af/at network devices. It does not have auto-detection functionality and supplies power to connected devices immediately upon connection. Powered devices or PoE splitters must conform to the standard IEEE 802.3af/at, and the powered device must support PoE pin 4/5 and 7/8 (-) midspan. This POE adapter is suitable for IEEE802.3af/at standard POE-powered devices such as IP cameras, VoIP phones, WiFi access points, and other similar equipment. It can also be used with an IEEE802.3af/802.3at standard PoE splitter for non-PoE devices. Color: Black Material: Plastic Key Features: - 8 LAN ports, 8 LAN and power ports - Power VoIP phones, IP cameras, WiFi access points, and more - Same voltage output to all ports; power is shared equally - 2.1 x 5.5 mm DC plug - LED power indicator light - Compatible with any Ethernet switch or router - Uses a 48V power adapter to deliver 48V power supply Main Specifications: 1) Input Voltage: DC12V48V (up to 10A) 2) LED: Indicates working status 3) Power pins: 4&5, 7&8 | Data pins: 1&2, 3&6 4) LAN ports: 8x RJ45 (data in), 8x PoE RJ45 (data & power out) 5) Network environment: 10/100Mbps Base-T | Ethernet cable: EIA/TIA 568 Cat.5 or Cat.5e 6) Data input: PC, Hub, Switch, Router, etc. 7) Operating temperature: 0C to +40C 8) Operating humidity: 20%90% RH, non-condensing 9) Storage temperature & humidity: -20C to +85C, 10%95% RH 10) Tip: Power voltage should not exceed DC48V Tips: - Select based on your devices power consumption. For stable operation, total power consumption must remain below the total power supply capacity. - POE cameras or APs should use a 48V (34A) power adapter or switching power supply to ensure the module powers on properly. - This PoE injector should be used with appropriate power adapters and compatible devices.