Item Type: Closed Loop MotorMaterial: Aluminum AlloyTorsion: 2.2NmShaft Diameter: Approx. 8mm / 0.3inDrive Parameters: Input Voltage: Minimum: 20VDC, Typical: 24VDC, Maximum: 48VDCOutput Current: Typical: 3A, Maximum: 4.2AStep Signal Frequency: Maximum 200KHzControl Signal Input Current: Minimum: 7mA, Typical: 10mA, Maximum: 16mAOvervoltage Protection: Typical 55VDCInput Signal Voltage: Typical 5VDCInsulation Resistance: Minimum 100M .wang-edit-text{ font-family:'Arial' !important; } .wang-edit-text table { border-top: 1px solid #000; border-left: 1px solid #000; } .wang-edit-text table td, .wang-edit-text table th { border-bottom: 1px solid #000; border-right: 1px solid #000; padding: 3px 5px; } .wang-edit-text table th { text-align: center; } 1MOTOR WITH DRIVER: Hybrid servo motor with 3D printer driver, which reduces complex wiring and greatly increases the installation space of the motor. 2HIGH EFFICIENCY: Adjust the current in real time according to the actual load, reduce the heating, and close to 9% of the torsion output capacity. 3HIGH TORSION: The high speed of the hybrid servo drive system is more than 30% higher than that of the open loop stepper motor, the effective torsion is more than 70% of the holding torsion. 4LESS INTERFERENCE: The space vector current control algorithm and vector smoothing filter technology based on feedback encoder can alleviate low frequency resonance. 5QUICK RESPONSE: Position response output and input command signal are almost synchronous in real time. Servo control provides large torsion output with high speed dynamic response.