This tiny breakout board for TI's DRV8835 dual motor driver can deliver 1.2 A per channel continuously (1.5 A ) to a pair of DC motors, and it supports two possible control interfaces for added flexibility of use: IN/IN and PHASE/ENABLE. With an operating voltage range from 0 V to 11 V and built-in protection against reverse-voltage, under-voltage, over-current, and over-temperature, this driver is a great solution for powering up to two small, low-voltage motors. The carrier board has the form factor of a 14-pin DIP package, which makes it easy to use with standard solderless breadboards and 0.1inch perfboards. Motor channels:2 Minimum operating voltage: 0V Maximum operating voltage: 11V Continuous output current per channel: 1.2A output current per channel: 1.5A Continuous parallel output current: 2.4A Maximum PWM frequency: 250kHz Minimum logic voltage: 2V Maximum logic voltage: 7V Reverse voltage protection: Yes Color: Green Material: PCB Package Contents: 1 * module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.