Made of materials, sturdy and . BEC 9V /12V output,Designed for Video mitter, Camera, Gimbal BEC 5V output, controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed BEC Vx output,Designed for Servos MCU: STM32F405RGT6, 168MHz , 1MB Flash; IMU: ICM42688-P; Baro: DPS310; OSD: AT7456E; : Micro-SD card slot 6x UARTs, 1x Softserial_Tx option(INAV);10x PWM outputs; 2x I2C; 3x ADC (VBAT, Current, RSSI) Built in inverter for SBUS input USB Type-C(USB2.0) FC Firmware : MatekF405-Wing (ArduPlane 4.4 or newer) INAV: MATEKF405SE (INAV 6.0 or newer) PDB Input voltage range: 9~30V (3~6S LiPo) w/ protection Current Senor: 220A, 3.3V ADC (INAV scale 150, 66.7A/V) Sense resistor: 100A continuous, 220A Battery Voltage divider 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ) BEC 5V output controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed Continuous current: 2 Amps BEC 9V /12V output Designed for Video mitter, Camera, Gimbal . Continuous current: 2 Amps 12V option with Jumper pad for stable 9V/12V output, input voltage should output voltage +1V BEC Vx output BEC 3.3V output Designed for external 3.3V peripherals Linear Regulator Continuous current: 200mA (Due to different batches, the printed words on the product be different, which does not affect use) Material: PCB colour: Blue Package Contents: 1 x F405-Wing-V2 1 x 20cm JST--4P to JST--4P Cable 1 Set x 2.54 Pins (Board is shipped unsoldered)