Using XC7Z020-2CLG400I chip xc7z020-2I The AD9363 chip is configured to use the AD9361 chip, with a frequency range of 70MHz-6GHz and a maximum sampling rate of 61.44MHz. After laboratory testing, no obvious difference from the AD9361 has been found so far PS 1GB DDR3 32bit bit width, frequency 1066M 32MB QSPI Flash, supports TF card (TF boot and QSPI boot can automatically switch, inserting the card is TF boot and removing the card is QSPI boot) Onboard JTAG circuit and USB-to-serial port enable power supply and debugging with one cable Description: 1. Support USB OTG, which can be master or slave. All USB interfaces adopt TYPE-C interface. The OTG mode is automatically recognized and the USB port is turned on for power supply 2. Using VCTCXO, the initial frequency accuracy is 0.5PPM, and supports PPS or 10MHz external taming 3. Gigabit Ethernet interface 4. The design current of all power rails in the digital part is 4A, which is sufficient. AD936x uses ADP1755 high-performance LDO to provide power to improve RF performance 5. Adopt 10-layer PCB wiring, impedance matching, and signal integrity design 6. The product adopts CNC shell to enhance heat dissipation and strength 7. It can be used right after booting, the system files are pre-burned in the TF card, and you can follow the introductory tutorial to get started 8. The software interface is libiio, which can be connected to software that supports libiio, such as iioscope, SDRsharp, Matlab, GNURadio, etc. Material: ABSandaluminum Color as shown Package Contents: 1 x Software Radio Development Board 4 x Antenna 1 Set Of Wires Note: Different Batches May Have Differences In Product Appearance, Color, And Printed Characters, Which Will Not Affect The Use Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is 1-3cm.