For Suzuki Bandit 650 2007-2015 GSF650 GSF1250 GSF 650 1250 Motorcycle Gear Indicator 1-6 Level Digital Touch Control Gear Meter

$279.00
+ $14.49 送货

For Suzuki Bandit 650 2007-2015 GSF650 GSF1250 GSF 650 1250 Motorcycle Gear Indicator 1-6 Level Digital Touch Control Gear Meter

  • 品牌: Unbranded

For Suzuki Bandit 650 2007-2015 GSF650 GSF1250 GSF 650 1250 Motorcycle Gear Indicator 1-6 Level Digital Touch Control Gear Meter

  • 品牌: Unbranded
建议零售价: $359.00
价格: $279.00
您节省了: $80.00 (22%)
由……售出:
$279.00
+ $14.49 送货

有货

我们接受以下付款方式

描述

Note: The product has a version with a mounting bracket and a version without a mounting bracket. Please choose the product that suits you according to your actual situation. Please note that for product beauty, products with mounting brackets do not have the word 'Gear' on the top of the surface. Special Function: Touch Sensor Robust Design High Speed Warning Auto Brightness Control Flipping the display upside down No need to cut any wires and no need for soldering Even if you do not run the motorcycle, you can complete the product settings. The setting can be completed when the motorcycle is completely stopped. Sign Description: C: Code Reading the firmware version L: Learning Learning the gear positions F: Filtering Adjusting the filtering (sampling period) b: Brightness Adjusting the sensitivity of the light sensor H: HSW High Speed Warning function E: ESW Engine Speed Warning function Upside down Flipping the display upside down Defaults Resetting all values to factory defaults Features: Condition: Light Color: Red/Blue/Green 1-6 Level IP68 Waterproof Gear display The Fact: FAST AND ACCURATE Instant and accurate indication of the selected gear (right after the clutch is released) for added control and safety. The sampling period can be adjusted to make the response quicker or slower, depending on shift speed and signal conditions. TOUCH SENSOR All settings can be done via the touch sensor so theres no opening on the housing, it is completely sealed and encapsulated in epoxy. The touch sensitive area is on the TOP of the unit. However, after programming, the unit can be mounted even with the top side stuck to the dashboard (via the sticky pads supplied) and will function properly. It can also be used with the optional GFYSHIP Mount. AUTO BRIGHTNESS CONTROL The brightness of the display is adjusted automatically according to the ambient light intensity. The sensitivity of the sensor can be fine-tuned in the menu. HIGH SPEED WARNING FUNCTION If you wish, you may set the unit to warn you when the set road speed and/or the set engine speed is exceeded. ROBUST DESIGN - Full SMT-design, encapsulated in epoxy - Flash memory to store user settings even with the battery disconnected - Only inspected, high quality components are built in - Each unit is extensively tested prior to shipping Fitment: For Suzuki GSF650 Bandit 2007-2015 For Suzuki GSF1250 N Bandit 2007-2013 For Suzuki GSF1250 NA Bandit 2007-2013 For Suzuki GSF1250 S Bandit 2007-2016 For Suzuki GSF1250 SA Bandit 2007-2016 Installation: 1. Gain access to the Gear Position Sensor (GPS) connector. Normally this involves the following: - Remove the seat - Lift up or remove the fuel tank Look for a matching connector on the bike to your model. You may find more than one of this connector under the fuel tank. You need the one that (normally) has Pink, Blue and Black/White wires. 2. Disconnect the GPS coupler. Make sure the gearbox is in Neutral and turn the ignition switch ON. Wait a few seconds. The Neutral indicator should NOT be lit with disconnected GPS coupler. After confirming this, turn the ignition OFF and proceed to the next step. 3. Connect the GFYSHIP plugs to the GPS coupler. 4. Connect the GFYSHIP Red wire to an ignition switched +12V power lead by using the Red wire tap connector supplied. Usage: Place the unstripped bike wire (switched +12V) inside the run channel. Close the side cover until latched. Cut off the excess length, then insert the unstripped tap wire (GIpro Red) completely and check its position. Insert the blade (u-contact) and press down by finger pressure. Then, fully depress the u-contact with pliers. Close the hinged top cover until latched. The power must be ON even when the engine run switch is switched off. We recommend tapping the Orange/Green (orange with thin green stripe) wire at the 2-pole rear brake light switch connector or at the diagnostic connector. Set Up: Note: If the unit does not indicate the gears correctly with the pre-set gear position values, youll need to start the Learning procedure.The TOP side of the housing is the touch sensitive area so it must be kept free, away from all objects. If the unit is in a mount, remove it first. - Have the gearbox in Neutral. - Have the ignition OFF (the display must be blank). - Turn the ignition ON and the engine stop switch to RUN position (the display should count up and then show 0). Wait at least 2 seconds. - With your index finger (without gloves) tap the top side of the unit and hold your finger until the first menu sign shows up. Remove your finger now. Note: If the gearbox is switched to a gear then accessing the menu will be disabled even if you shift back to neutral. Cycle the ignition key to start overIf the unit does not indicate the gears correctly, start the Auto-Lea
  • Fruugo ID: 317080662-705264712
  • EAN: 592080446989

产品安全信息

请参阅下面列出的特定于该产品的产品安全信息

以下信息由销售该产品的独立第三方零售商提供。

产品安全标签

CE Mark
安全警告: Not suitable for children under 36 months, Choking Hazard, Adult supervision recommended
原料: Polymethylsilsesquioxane
制造商零件号: 592080446989
型号: 592080446989
序列号: 592080446989
批号: 592080446989

配送 & 退货

在 3 天内发货

  • STANDARD: $14.49 - 之间的交付 周三 05 十一月 2025–周四 13 十一月 2025

从 中国 送货。

我们会争取将您订购的产品按照您的规格完整地配送给您。不过,万一您收到不完整的订单,或收到的产品与您订购的不同,或者有其他原因让您对订单不满意,您可以要求全部或部分退货,您将收到相应产品的全额退款。 查看完整的退货政策

产品合规详细信息

请参阅下面概述的针对该产品的合规性信息。

以下信息由销售该产品的独立第三方零售商提供。

制造商:
以下信息概述了在Fruugo销售的相关产品的制造商联系信息。

  • Govee Moments Limited
  • Govee Moments Limited
  • Room 023, 9/F, Block G, Kwai Shing Ind Bldg (Stage 2) 42-46 Tai Lin Pai Road, Kwai Chung, Nt
  • Hong Kong
  • HK
  • 999077
  • govee2020@outlook.com
  • 085244096945

欧盟负责人:
以下信息概述了欧盟负责人的联系信息。该负责人是位于欧盟的指定经济运营者,负责有关销售到欧盟的相关产品的合规义务。

  • Van Lavazza
  • Y & H S.R.L.
  • Via Gravina 21 MT matera
  • Puglia
  • Trani
  • IT
  • 75100
  • itlyhsrl@gmailcom
  • 0039 3917722149