TFT LCD Screen for Galaxy S10+ SM-G975 Digitizer Full Assembly with Frame, Not Supporting Fingerprint Identification Before Installation Notes Tip 1: Test before installation When testing, do not remove any protective film or tags. Pay attention to static electricity. Before attempting any repair, ground yourself using an ESD (electrostatic discharge) strap to prevent static damage to internal electronic components. Wear eye protection and handle glass carefully to avoid injury. Tip 2: Simulate testing Screen replacements are fragile. Test the unit before full installation. Partially disassemble the phone, connect the motherboard, LCD or screen, o cable, and new replacement, then power on to test functionality. If the test is successful, proceed with installation. If there is no display, contact support immediately. Do not force installation if the screen does not work. Responsibility ends once the screen is installed. Tip 3: Avoid cable over-bending Do not bend the LCD cable beyond 90 degrees, as excessive bending may cause display issues such as black screen. Product Information 1. Replacement LCD screen and touch screen digitizer assembly with frame for Galaxy S10+ SM-G975 2. Replaces old, broken, cracked, or damaged screens 3. Restores device appearance 4. Designed for accurate fit and function 5. Each unit is tested and confirmed in good condition before shipping 6. Professional installation is recommended. No responsibility assumed after installation 7. Note: Does not support fingerprint identification