Features: Easy to Take Ice: Press gently the ice can fall off from the mold and the ice can be easily collected. Easy to Inject Water: The mold can be filled with water in 3 seconds. The mold barrel has strong sealing small and round and saves space. Food Grade Silica Gel: The mold is made of safe and non-toxic food grade silica gel which is not easy to aging. 1.3cm Ice Cubes: The mold can make multiple 1.3cm ice cubes at one time which is suitable for all kinds of cold drinks. Instant Demoulding: There is a groove in the middle of the mold which can be washed down with warm water and demoulded instantly without waiting. Specifications: Material: Abs+ silicone Size: 9*9*8cm Production Steps: 1. Pull out the plastic inner cylinder and pour water into the silica gel container which is slightly more than 2 spaces and not more than 2 and a half spaces. 2. Slowly insert the inner cylinder with cover into the silicone body pay attention to rotating and pressing it to the bottom and then gently pinch the silicone side under the eaves of the cover to exhaust so as to prevent the inner cylinder from floating. 3. Place the mold at room temperature for a few minutes. If you don't want to wait and press hard you can inject an appropriate amount of hot water into the inner cylinder pour out the hot water in about 10 seconds and then you can easily pull out the inner cylinder. 4. Squeeze the outer wall of silica gel and constantly adjust the angle to separate the ice. includes: 1 * Mold