JW4106S Optical Fiber Fusing Splicer Fiber Optic Fusing Splicing Welding MachineEU Plug 220V Condition: Item Type: Fusing Splicer Material: ABS + Iron Model JW4106S Alignment Method Precise core alignment and cladding alignment Applicable Fibers Any common optical fibers, rubber-insulated fibers and jumpers that meet requirements of ITU-TG.651-653, ITU-TG.655 and ITU-TG.657. Optical Fiber Diameter Cladding: 80~150μm, coating layer: 0.1~3mm Cutting Length 5~16mm (coated optical fiber diameter ≤250μm); 10mm (coated optical fiber diameter: 0.25-3mm) Fusing Splicing Consume (Typical Value) 0.02dB(SMF); 0.01dB(MMF); 0.04dB(DSF); 0.04dB Return Loss (NZDSF) Better than 60dB Fusing Splicing Time (Typical Value) 7s Heating Time (Typical Value) 18s Pulling Force Test 1.96~2.25N Built-in Drive Motor 4 Motor Thermal Shrinkage Tube 60mm, 40mm and series of thermal shrinkage tubes Graphical Display High-performance 4.3 inch LCD Display Magnification Time 320 Times / 88 Times Fusing Splicing Record 10000 Groups Battery Capacity 11.1V, 6400mAh, typical value of fusing splicing and thermal cycle is 220 times Battery Service Life Cycle charging time reaches 300~500 times, can be replaced by customers Electrode Service Life Typical value is 4000 times, can be replaced by customers Construction Lighting Built-in lights with high-brightness and wide lighting area Working Environment Temperature: -10~50℃; Humidity: 0~95%RH, Height above Sea Level: 0~6000m Operation Interfaces GUI graphical operation interfaces External Power Supply AC: 0~1.5A; DC: DC10~15V External Port USB / Memory Card Interface Product Size Approx. 165 x 125 x 140 mm / 6.5 x 4.9 x 5.5 in Weight Approx. 5910g / 208.5oz Function: 1. Precise fiber core alignment, ultra-low fiber fusing splicing consumption. 2. 320 times image magnification, 5mm fusing splicing for fibers of ultra-short cutting length. 3. 7s fast fusing splicing, 18s highly efficient heating. 4. 300 groups of fusing splicing modes, 100 groups of heating modes. 5. High-definition liquid crystal display and high-strength protective panel to observe X-axle and Y-axle optical fibers at the same time. 6. 3 in 1 fixture can weld single core, rubber-insulated wire, tail fiber 7. Small size and light weight. 8. USB and memory card interface, U-disk automatic software upgrade. Built-in modular lithium battery, supports 220 times of splicing and heating cycles.