LAN563G-HS10 Household Intelligent Network Remote Temperature Monitoring System 1. Power supply mode: POE or USB 2. Device power: less than 1.5W 3. Working voltage: 5V 4. Working current: less than 300mA 5. The length of the probe can reach 10 meters Factory default parameters 1. Username: Pcsensor 2. Password: admin 3. IP: 192.168.1.188 4. Gateway: 192.168.1.1 5. Subnet mask: 255.255.255.0 6. Port: 5200 7. Web page refresh interval: 5 seconds 8. Website URL: http:192.168.1.188:5200 (equipment supports secondary development, please consult sales staff for details) Product use: If the user is just starting to use the device, please follow the steps below: 1. Access the probe The device can be connected to 2 probes at the same time (different types of probes can be mixed), there are 3 modes of probes, respectively 1.1.DX probe: Temperature range: -40 to 125 degrees Celsius, accuracy 0.05 degrees Celsius 1.2.TX probe: Temperature range: -40 to 125 degrees Celsius, accuracy 2 degrees Celsius 1.3.HX probe: temperature range: -40 to 125 degrees Celsius, accuracy 0.3 degrees Celsius; humidity range: 0-100%, accuracy 3% 2. Access the network cable Use a network cable to connect the device to the computer, and modify the network parameters of the computer to: IP: 192.168.1.100 (the last digit is not 188); subnet mask: 255.255.255.0; gateway: 192.168.1.1 3. Plug in USB power 4. Open the software 4.1. After opening the software, it will pop up whether to load historical devices, select No 4.2. Then the Add Device dialog box will pop up, enter the IP and port of the device, the factory default IP is 192.168.1.188, and the port is 5200. Then click OK to add the device 5. Enter the device password: in order to prevent the device from being arbitrarily modified, each device can set a password, the default password is admin 6. Select Mode Since different devices have different measurement and control modes, the user needs to select the appropriate measurement