Features: Brand new and high quality The Manta M5P V1.0 Control Board is created for Klipper running, designed with the same connector. Provides you with a secure connection with all versions of, and definitely CB1. A screw-down installation is also available. Manta M5P uses a 32-bit 64MHZ ARM Cortex-M0+Series-STM32G0B1RET6 chip, can also run without CB1. Supports 5-axis stepper motor drivers, integrated driver UART modes, easily configurable. Supports CAN Bus/Filament runout sensor, built-in interface port for connecting acceleration sensor to enable Klipper input shaping. The new E-FUSE is equipped, which can react quickly, improve self-protection capability, and greatly reduce motherboard burnout caused by short circuits. The motherboard reserves interfaces for switch expansion, supports selection, (24V, 12V, 5V) selection, and for users to use Klipper firmware to connect external acceleration sensor for acceleration compensation. Specifications: Material: Plastic Size: Approx. 137.5x95mm/5.41x3.74 inches Note: 1. Please allow 1-2cm errors due to manual measurement, make sure you don't mind before ordering. 2. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Package includes: 1x Control Board