Usage Tips: AdBlue OBD2 for MAN Euro 6 truck scanner, AdBlue emulator for Euro 6 trucks with NOX sensor, 8 in 1 or 9 in 1 functionality, AdBlue OBD2 emulator for MAN Euro 6 EURO 6 AdBlue emulator disables system: AdBlue system (fully) AdBlue NOX sensor, DPF system, DPF temperature sensors, DPF regeneration After installing Euro 6 emulator, you can remove: DPF sensors - YES, NOx sensor - YES (except first NOx sensor in DAF), AdBlue temperature sensor(s) - YES, AdBlue pump - YES, AdBlue level sensor - YES, AdBlue ECU - YES Note: It is possible to disable AdBlue system by installing an AdBlue emulator (programmable device) into the vehicle. You can switch it on or off at any time. EURO 6 AdBlue emulator installation guide: Emulator for MAN Euro 6 does not require learning. Install the emulator under the metal cover of the AdBlue pump on the right side behind the cab, disconnect the plug from the AdBlue pump, and connect the emulator. Next, remove the following fuses: F894 (Multisensor in AdBlue tank) F738 (+30 Signal of AdBlue pump) F1084 (NOx sensor upstream) Fuse F737 becomes the fuse for the emulator. Fuse F1109 is for the NOx sensor downstream and A1191 muffler temperature sensor. This sensor must function correctly for DPF regeneration. Finally, disconnect power from the NOx downstream sensor. Two options: cut pin 1 in the NOx sensor plug, or (preferably) remove pin 10 in the X3212 plug. This plug is located on the rear of the engine on the right side. It is a TE plug (16 pin) with a yellow key. Color: As shown Material: Plastic Package Contents: 1 x Emulator for MAN Euro 6 Only the above package content; other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture to differ slightly from the actual item. Measurement may vary by +/- 1-3 cm.