Working environment: 1. Ambient temperature: 540C 2. Relative humidity of environment: 85% Use, care, and precautions: The inside of the sensitive bulb is completely filled with liquid. If bubbles are found, gently shake the electrode (like a thermometer) to remove the bubbles in the sensitive bulb; otherwise, it will affect the accuracy of the test. Calibration and testing of the electrode and the pH meter: 1. Connect the pH electrode to the input of the pH instrument and ensure the connection is correct. 2. Perform the calibration according to the instruction manual of the instrument, and the calibration result should be measured. Storage and maintenance of the liquid-filled composite pH electrode: 1. The electrode uses electrical space. Please clean the electrode with distilled water and place it in a protective bottle. It will be activated by injecting the solution before the next test. 2. If the electrode is not used for a long period, it must be rinsed and the remaining distilled water must be absorbed. 3. The sensitive glass bulb on the front of the electrode should not be in contact with hard objects. Any damage or scratches will render the electrode invalid. 4. After long-term use of the electrode, the electrode's slope and response rate may decrease. It is possible that the sensitive bulb becomes contaminated or the liquid junction becomes blocked, which can passivate the electrode. In such cases, the response speed will be considerably slower, the slope will be reduced, or the reading will become unstable. Choose the appropriate cleaning method according to the nature of the pollutant. Technical specifications: Heating voltage: 50.2V (AC/DC) Working current: 510mA Detectable concentration range: pH 014 Detection temperature range: 080C Response time: 5 seconds Settling time: 60 seconds Component power: 0.5W Operating temperature: -1050C (rated temperature 20C) Humidity: 95% relative humidity (nominal humidity 65% relative humidity) Module size: 42mm x 32mm x 20mm Output: Analog voltage signal output With 4x M3 mounting holes