Four-wire PWM fan temperature control governor with control signal 10V, support common four-wire fan.Support conventional high-voltage EC fan four-wire control (10V PWM signal);support low temperature shutdown fan (PWM off or extended relay to turn off fan power ).Wide voltage operation DC11-55V; Supports 2.5KHZ and 20KHZ frequency ; Supports anti-timing fans.Power supply voltage: DC11-55V (circuit operating voltage)Working current: Less than 0.1AFan current: Less than 5A (on-board connector withstand capability, if you need to control higher power, you only need to take the power cord separately)PWM range: 5-100 or 0 (% plus or 0.3%)PWM frequency: 20KHz or 2.5KHz (2%)PWM signal amplitude: 10.5V (no load)Temperature measurement range: -9.9-99.9 CTemperature measurement error: error within 0-50 C is less than 1.2 C, other range error is less than 2 CInterface introduction:Power connector (blue screw terminal): The main power input interface supplies power to the control board and the fan.Fan interface (white VH3.96-4P socket): fan output interface, refer to the picture for line sequence.Temperature probe interface: Connect NTC probe parameter 10K B=3950.Alarm signal port (WORK): Outputs a high level during normal operation and outputs a low level when the fan is abnormal.Relay interface (RELAY): An expansion interface that drives a 9V or 12V relay that can be used to control the fan power line. When the fan control is stopped, the relay is disconnected.Material:plasticcolour:greenPackage Contents:1 x Controller