1. ODV - Specifically designed for classic and skirting boards. It uses a high-speed amplification circuit to identify the best signal from the traditional host, convert it into a component signal, and connect it to devices such as digital multipliers to provide gamers with the best native experience. 2. The R, G, and B keys of this product can respectively adjust the color levels of the red, green, and blue signals to meet the color needs of gamers. 3. An LM1881 switch separation chip is added to separate and process the different synchronization signals of the host and the skirting board. 4. Power input: - USB 5V / 1A 5. Input interfaces: European standard SCART input interface, universal connector 6. Input support: Supports all analog signal inputs, and the chip supports separated signals. - 240P / 480i / 288P / 576i / 480P / 720P / 1080i 7. Output interface: YPBPR component output 8. Output signal: Converted into an analog signal 9. Delay: Analog circuit conversion without adding extra delay 10. Product dimensions: 75 x 57 x 26 mm 11. Conversion direction: One-way conversion to component signals 12. Installation and configuration: 1. Connect the RGB output of the host/substrate to the SCART/universal input interface of the ODV - RGB. 2. Connect the component output end of the rear panel of the ODV - RGB to the input end of the component TV. 3. If necessary, connect an external power supply, use a 5V power supply and connect it to the USB port. 4. Connect the audio output to an audio device or the left and right channel inputs of the ODV. 5. Use the R, G, and B keys on the product to respectively adjust the colors of the red, green, and blue signals. 6. Use the synchronization signal switch to switch between the two signals. 13. Color: Black 14. Material: ABS 15. Package contents: 1. One SCART to YPBPR converter 2. Only the above package contents are included, and other items are not included. Note: Light and different monitors may cause the color of the item in the picture to differ slightly from the actual one. The measurement tolerance is +/- 1 - 3 cm.