Features: Technical Support: High performance RF Chip, crystal oscillator frequency stabilization, frequency point accuracy. Long-range Unobstructed Transmission: It has high transmission sensitivity and no signal obstacles. Wide Range of Copies: It can copy most of the fixed code and learning code wireless remote control. Scope of Application: It includsvehicle central locking systems, garage doors, electronic doors, car sunroofs, car and motorcycle alarms. Copy speed and Simple Operation: It cansaves you time and does not affect the original remote control. Specifications: Compatible IC chips: 2260(as,PT2260,SC2260,HS2260 LX2260,HX2260); 2262(as,PT2262,SC2262,LX2262,HS2262,HX2262), PT2264,PT2240(LX2240 LX2241 SCL2240), HT6207, HT6010, HT6012, HT6013, HT6014, HT12D, HT46F49E, PIC16F630 ULN2003, etc. RF frequency type: 315/868/433 (listed products only support 433.92 MHZ) Copy the existing remote control so that you always have a backup of. Vehicle central locking system, garage door, electronic doors,Electrical/Home Automation, i.e. lights, Car sunroofs, car/motorcycle alarm. Operating current: 12mA Working frequency: 433.92Mhz Transmitting power: 10mW Transmission distance: 50m (open) Frequency deviation: 0.2MHz Transmission rate: 50--60KHZ Operating temperature: -20~70 Storage temperature: -10~ 50 Humidity85% or lower How to program. Step 1 Clear the history code from the duplicator. Press and hold the A and B keys, the LED flashes slowly 3 times and then goes out, then press and hold the A key without moving, release the B key, immediately press the B key 3 times in succession (this action must be in 3 seconds), then the LED flashes rapidly, indicating that the code has been cleared. Step 2 Copy the code from the original transmitter. Place the cloned remote and the original remote side by side. Make sure they are touching. Press one button on the original remote and one button on the clone remote at the same time and hold until the LED on the clone remote blinks steadily. The blue LED will blink 3 times rapidly, then stop for a second, then blink steadily. 2. Release both buttons. Programming is successful. Clone the other buttons in the same manner. Restore: If you accidentally remove the cloned remote code, you can press A and D at the same time. After 3S, the LED will blink 3 times and then start blinking rapidly to indicate that the cloned remote code has been restored. includes: 1 *Remote Control