Tool kit- clone of Fox Trek Isostrut 803-01-436 Iso Strut service/rebuild set This auction is a 3 piece set for the trek fox isostrut -._x000D_ 1st we have a Trunnion adaptor for the trek FOX isostut - . This clamps around the isostrut and holds the tabs so you can use it in a vise or some a hand dyno under preasure. This is made from 6061 aluminum and is CNC machined a Trek FOX Isostrut adaptor used to hold the shock during rebuild and to adapt it to a trunnion tool so you can use it on a hand dyno. This is made from 6061 alumminum and is CNC machined for a tight tolorance fit. This has Hardened steel pins and fit a 44mm trunion tool .This fits the same as fox part number 398-00-844._x000D_ Note: You will need a long trunnion tool as the isostrut has a lot of height past the tool._x000D_ The second tool fits the FOX isostrut found on trek bikes -. This tool is used to remove the isostruts negative plate. This is needed for a rebuild or shock service._x000D_ The last item in the auction is for the threaded Trunnion adaptor for the trek FOX isostut - . This threads into where the shock tube would thread so you can dyno the shock using a extra long trunnion tool before assembling or air pressure. This is made from 6061 aluminum and is CNC machined. These all have a raw machined finish. _x000D_ Due to differences in shooting equipment, displays, and production batches, the product may have slight color differences. This is normal, please refer to the actual product. We have tried our best to restore the true color through professional equipment, but we still recommend that you watch it under natural light for the most accurate visual effect.